Gasfitter in San Antonio, TX

Gas fitting is the work of piping natural gas safely from the meter to each appliance: sizing it correctly, joining it soundly, supporting it, and testing it under pressure before anything is lit.

A gas system is designed around load. Every appliance has an input rating, and the pipe has to deliver all of them at once without starving the furthest one. When a tankless heater, a range or an outdoor kitchen is added, that calculation changes, and we redo it before running pipe.

Repairs follow the same discipline. A leak is located precisely, the joint or section is remade, and the system is pressure tested and held before service is restored. If you smell gas, leave the house and call the gas utility first. We take it from there once the area is safe.

In this specialtyThe services involved

Gas Line InstallationAdding a gas appliance means extending the gas system safely: sizing the pipe for the total load, routing it with proper support and protection, installing shutoffs where required and pressure testing before anything is connected. Gas work does not leave room for shortcuts.Read more

Gas Line RepairA gas leak is never a do-it-yourself project and never a wait-and-see problem. If you smell gas, leave the house first and call the gas utility from outside. Once the utility has made the area safe, we locate the leak, repair it and pressure test the system before service is restored.Read more

Tankless Water Heater InstallationA tankless water heater heats water as it flows instead of storing it, so it will not run out and takes up very little space. Getting that result depends on sizing, gas supply, venting and water quality. A tankless unit installed on undersized gas pipe or hard water will disappoint.Read more

Water Heater RepairWhen hot water runs out early, turns lukewarm or stops altogether, the cause is usually a specific part rather than the whole tank. We test the components that commonly fail, repair what makes sense, and tell you directly when a tank is not worth fixing.Read more